Changeset 2662 in ntrip for trunk/BNC/bnchelp.html


Ignore:
Timestamp:
Nov 10, 2010, 11:50:58 AM (14 years ago)
Author:
weber
Message:

Typos

File:
1 edited

Legend:

Unmodified
Added
Removed

  • trunk/BNC/bnchelp.html

    r2661 r2662  
    11841184</p>
    11851185<p>
    1186 QuickStart means that BNC operates for the period of 2 minutes in a mode where an introduced reference coordinate is constrained. The PPP solution is expected to converge within this time span. You may need to create your own 'reference coordinate' through running BNC for an hour in normal mode before applying the QuickStart option. The following options are available:
    1187 <ul>
    1188 <li>Option 'None' means that BNC shall neither plot a time series of dispacements nor start in QuickStart mode.</li>
     1186QuickStart means that BNC operates for the period of 2 minutes in a mode where an introduced reference coordinate is constrained. The PPP solution is expected to converge within this time span. You may need to create your own reference coordinate through running BNC for an hour in normal mode before applying the QuickStart option. The following options are available:
     1187<ul>
     1188<li>Option 'None' means that BNC shall neither plot a time series of displacements nor start in QuickStart mode.</li>
    11891189<li>'Plot - Start position' will let run BNC in normal mode and plot a time series referred to the very first determined set of coordinate components.</li>
    11901190<li>'Plot - X Y Z' will let run BNC in normal mode and plot a time series referred to entered coordinate components XYZ.</li>
    11911191<li>Select 'QuickStart - Static' to run BNC in QuickStart mode with observations from a stationary receiver located at known position XYZ.</li>
    1192 <li>'QuickStart - Mobile' also allows to run BNC in QuickStart mode. However, the receiver may leave its known initial XYZ start position after staying there for two minutes.</li>
     1192<li>'QuickStart - Mobile' also allows running BNC in QuickStart mode. However, the receiver may leave its known initial XYZ start position after staying there for two minutes.</li>
    11931193</ul>
    11941194Default selection for 'Origin' is 'None'. Note that displacements time series plots make only sense for a stationary receiver.
Note: See TracChangeset for help on using the changeset viewer.