Specify the full path to a file where PPP results are saved as NMEA messages.
")); _pppNMEAPortLineEdit->setWhatsThis(tr("Specify an IP port number to output PPP results as NMEA messages through an IP port.
")); - _pppOriginComboBox->setWhatsThis(tr("Select an origin for a North/East/Up displacements time series plot in the 'PPP Plot' section or for operating BNC in QuickStart mode starting at a known position.
- 'Plot - Start position' will let BNC plot a time series referred to the very first determined set of coordinate components.
- 'Plot - X Y Z' will let BNC plot a time series referred to entered coordinate components XYZ.
- 'QuickStart - Static' allows to run BNC in QuickStart mode with observations from a stationary receiver located at position XYZ
- 'QuickStart - Mobile' also allows to run BNC in QuickStart mode. However, the receiver may leave its initial XYZ start position after staying there for two minutes.
Note that displacements time series plots make only sense for a stationary receiver.
")); + _pppOriginComboBox->setWhatsThis(tr("Select an origin for a North/East/Up displacements time series plot in the 'PPP Plot' section or for operating BNC in QuickStart mode starting at a known position.
- 'Plot - Start position' will let BNC run in normal mode and plot a time series referred to the very first determined set of coordinate components.
- 'Plot - X Y Z' will let BNC run in normal mode and plot a time series referred to entered coordinate components XYZ.
- 'QuickStart - Static' allows to run BNC in QuickStart mode with observations from a stationary receiver located at known position XYZ
- 'QuickStart - Mobile' also allows to run BNC in QuickStart mode. However, the receiver may leave its known initial XYZ start position after staying there for two minutes.
Note that displacements time series plots make only sense for a stationary receiver.
")); _pppSigCLineEdit->setWhatsThis(tr("Enter a sigma for your code observations in meters.
5.0 (default) is likely to be an appropriate choice.
")); _pppAverageLineEdit->setWhatsThis(tr("Enter the length of a sliding time window in minutes. BNC will continuously output moving average positions computed from those individual positions obtained most recently throughout this period.
An empty option field (default) means that you don't wont BNC to output moving average positions.
"));