Changeset 2652 in ntrip

Timestamp:

Nov 7, 2010, 8:55:13 PM (14 years ago)

Author:

weber

Message:

Online help for QuickStart

File:

• trunk/BNC/bncwindow.cpp (modified) (1 diff)

trunk/BNC/bncwindow.cpp

@@ -468 +468 @@
   _pppNMEALineEdit->setWhatsThis(tr("<p>Specify the full path to a file where PPP results are saved as NMEA messages.</p>"));
   _pppNMEAPortLineEdit->setWhatsThis(tr("<p>Specify an IP port number to output PPP results as NMEA messages through an IP port.</p>"));
-  _pppOriginComboBox->setWhatsThis(tr("<p>Select an origin for a North/East/Up displacements time series plot in the 'PPP Plot' section or for operating BNC in QuickStart mode starting at a known position.</p><p> - 'Plot - Start position' will let BNC plot a time series referred to the very first determined set of coordinate components.</p><p> - 'Plot - X Y Z' will let BNC plot a time series referred to entered coordinate components XYZ.</p><p> - 'QuickStart - Static' allows to run BNC in QuickStart mode with observations from a stationary receiver located at position XYZ</p><p> - 'QuickStart - Mobile' also allows to run BNC in QuickStart mode. However, the receiver may leave its initial XYZ start position after staying there for two minutes.</p><p>Note that displacements time series plots make only sense for a stationary receiver.</p>"));
+  _pppOriginComboBox->setWhatsThis(tr("<p>Select an origin for a North/East/Up displacements time series plot in the 'PPP Plot' section or for operating BNC in QuickStart mode starting at a known position.</p><p> - 'Plot - Start position' will let BNC run in normal mode and plot a time series referred to the very first determined set of coordinate components.</p><p> - 'Plot - X Y Z' will let BNC run in normal mode and plot a time series referred to entered coordinate components XYZ.</p><p> - 'QuickStart - Static' allows to run BNC in QuickStart mode with observations from a stationary receiver located at known position XYZ</p><p> - 'QuickStart - Mobile' also allows to run BNC in QuickStart mode. However, the receiver may leave its known initial XYZ start position after staying there for two minutes.</p><p>Note that displacements time series plots make only sense for a stationary receiver.</p>"));
   _pppSigCLineEdit->setWhatsThis(tr("<p>Enter a sigma for your code observations in meters.</p><p>5.0 (default) is likely to be an appropriate choice.</p>"));
   _pppAverageLineEdit->setWhatsThis(tr("<p>Enter the length of a sliding time window in minutes. BNC will continuously output moving average positions computed from those individual positions obtained most recently throughout this period.</p><p>An empty option field (default) means that you don't wont BNC to output moving average positions.</p>"));