- Timestamp:
- Dec 7, 2009, 9:54:52 PM (15 years ago)
- File:
-
- 1 edited
Legend:
- Unmodified
- Added
- Removed
-
TabularUnified trunk/BNC/bncwindow.cpp ΒΆ
r2094 r2103 385 385 _serialFileNMEALineEdit->setWhatsThis(tr("<p>Specify the full path to a file where NMEA messages coming from your serial connected receiver are saved.</p>")); 386 386 _serialHeightNMEALineEdit->setWhatsThis(tr("<p>Specify an approximate 'Height' above mean sea level in meter for your VRS to simulate an inital NMEA-GGA message.</p><p>The setting of this option is ignored in case of streams coming from physical reference stations.</p>")); 387 _pppMountLineEdit->setWhatsThis(tr("<p>Specify a mountpoint if you want BNC to derive coordinates for the affected receiver position through a PPP solution.</p><p>Note that PPP in BNC requires to also pull a stream carrying RTCM Version 3 satellite orbit and clock corrections to Broadcast Ephemeris. Pulling in addition astream carrying Broadcast Ephemeris messages inshort repetition rates is suggested.</p>"));387 _pppMountLineEdit->setWhatsThis(tr("<p>Specify a mountpoint if you want BNC to derive coordinates for the affected receiver position through a PPP solution.</p><p>Note that PPP in BNC requires to also pull a stream carrying RTCM Version 3 satellite orbit and clock corrections to Broadcast Ephemeris.</p><p>Pulling in addition a third stream carrying Broadcast Ephemeris messages in high repetition rate is suggested if such messages are comeing from the receiver only in low repetition rate or even not at all.</p>")); 388 388 _pppStaticCheckBox->setWhatsThis(tr("<p>By default BNC considers the rover receiver as mobile.</p><p>Tick 'Static' to consider a static observation sitatuion and adapt appropriate filter characteristics for that.</p>")); 389 389 _pppUsePhaseCheckBox->setWhatsThis(tr("<p>By default BNC applies a PPP solution using an ionosphere free P3 linear combination of code observations.</p><p>Tick 'Use phase obs' for an ionosphere free L3 linear combination of phase observations.</p>"));
Note:
See TracChangeset
for help on using the changeset viewer.