Manual for rtcm3torinex The program rtcm3torinex is an real-time converter from NTRIP streamed RTCM3 data into the RINEX format. The generated RINEX is somewhat limited due to the streaming character of the conversion: - Header records can only represent data, which is known after receiving the very first epoch. Data rate, position, number of observations and any such additional fields cannot be provided. - The number of observables cannot change during the program runtime. Only the observables, which exist in the first epoch are outputted. If there are new observables later on, these are ignored. - Only known data types are interpreted. This means only GPS data at the moment. Send me new RTCM3 data files and data support can be improved. See contact address at the end of this document. - If the ambiguity field in the RTCM3 data is not set, the output will be no valid RINEX. All values will be stored modulo 299792.458. A COMMENT line will tell you, when this happens. It would be necessary to approximately calculate the range to fix the ambiguity (needing ephemeris/alamanac and easy positioning algorithm). Usage: rtcm3torinex -s server -u user ... -d --data the requested data set -f --headerfile file for RINEX header information -s --server the server name or address -p --password the login password -r --port the server port number (default 80) -u --user the user name The fields --user and --password are used to specify the access data for the NTRIP server. The arguments --server and --port are used to specify the NTRIP server itself (defaults to "www.euref-ip.net" port 80). The Argument --data must be used to specify the RTCM3 input data stream. If it is not given, you will be shown the source table of the selected NTRIP caster. Additionally the argument --headerfile can be used to provide additional header information. The file must contain normal RINEX observation file header lines. The given lines overwrite the automatical generated lines. Overwriting the lines "# / TYPES OF OBSERV" and "TIME OF FIRST OBS" usually is a bad idea and you will get warned if you do so. The line "END OF HEADER" is ignored. Unknown lines or COMMENT lines will be appended before the "END OF HEADER". NOTE: The tool does not check the input lines for validity. So be sure to use correct RINEX specifiers as well as correct alignment. To stop RINEX output send the program a killing signal. Following signal sources are supported: signal number usual source of the signal --------------------------------------------------------------------------- SIGINT 2 pressing CTRL+C in the shell running the tool SIGQUIT 3 pressing CTRL-\ or sending QUIT signal SIGTERM 15 called kill with the process number of rtcm3torinex SIGPIPE 13 the output or input of rtcm3torinex has been closed The programm will be terminated after the current epoch has been finished. You will not get corrupted RINEX files. Contact me with your comments, suggestions, improvements, patches, ... Dirk Stöcker EuroNav Service GmbH http://www.euronav.de/ stoecker@euronav.de 2006-01-12